If there isn t a suitable joist or brace available but you have access to the framing through the attic add a brace that can support the fan.
Can you replace light with ceiling fan.
If one of the light sockets on your ceiling fan has gone bad don t despair at least not before you ve checked things out.
If you need to convert a can light to a ceiling fan to accommodate a new design the can converter recessed light conversion kit for ceiling fans can help.
Some may twist off though.
The adapter for our recessed light conversion kit for ceiling fans is easy to install but if you need additional installation instruction check out our videos and installation manuals.
The advantage of this approach is that you don t have to run new wiring.
Usually you ll need to unscrew a few screws to take off the canopy.
First remove the existing box then insert the brace up through the hole and secure it in position by ratcheting the mechanism into place.
Remember that the stress you cause by pulling the fan speed chain and light chain can loosen the smaller junction box.
If you do not have access to work above the ceiling you can install an expanding metal brace from below to support the ceiling box and fan.
If you re installing a new electrical box fasten it to a ceiling joist or a 2 by 4 wood brace between two ceiling joists.
Ceiling fan brace and box kit.
The vibration the fan has when the blades are spinning can also loosen the small junction box.
The screws will likely be near the ceiling.
It just depends on your fan.
Ceiling fans often come with a mounting flange beneath the fan motor that can accommodate an optional light kit.
Light sockets on ceiling fans are pretty much the same as those on standard lighting fixtures and many are replaceable.
An outdated ceiling fan can be replaced with a modern light fixture to give a room a fresh look.
However and this is very important you can t just hang the fan from the existing.
If you can t figure it out try looking up the fan on the internet for help.
Here we ll show how to replace an old light fixture with a new ceiling fan and light in a room with no attic above.
If you are using the same small junction box from the old light fixture it will increase the chances of the fan coming loose or becoming unstable.
You shouldn t have to replace the whole fixture to get a light working again.
The fan connects to the existing cable from the old light.