I got the water tested and it was at 3200.
Aqua rite chlorine generator inspect cell.
I guess the cell is dead.
Aqua rite salt chlorinator has a built in reminder to inspect and clean the cell every 500 hrs.
To manually reset the inspect cell led press and hold the diagnostics button until led goes out approximately 3 to 5.
T 15 is the factory default.
I have an aqua trol since 2011.
Your salt level is between 2500 2600 parts per million ppm.
The flashing inspect cell led and reset the countdown timer for another 500 operational hours.
Using information provided by hayward pool we have created the following troubleshooting guide to help pool owners understand the diagnostic codes and quickly.
How to set turbo cell type before operation the aqua rite must be configured for the chlorinator cell that will be used.
Check salt inspect cell led s will be on when salt level is 2300ppm or less.
Nsf tested and proven genuine hayward turbocells have reliably delivered chlorine for nearly two decades.
This is more of an indicator light than anything else.
Producing enough chlorine for pools up to 15 000 gallons.
The check salt inspect cell led s will stay on when.
Aqua rite chlorine generator cele turbo cell control electronics hayward.
I have repaired the thermister several times over the years and replaced the lcd display board.
How to reset inspect cell light.
It always stays at 1600.
Inspect cell led will flash by itself when 500 operational hour countdown timer has expired.
The check salt inspect cell led s flash together when.
The 1 salt cell is also the best value saving 50 or more over conventional chlorine.
I have a older 2001 aqua rite chlorine generator with tcell 15.
If the check salt light is lit on a hayward aqua rite salt chlorinator it could mean a number of things.
Chlorine production is halted.
First check the display salt reading if it s 2 700 ppm or lower the check salt light will come on.
Just like any other salt chlorine generator the aqua rite may need a quick tune up from time to time.