Applying Vinyl Siding Over Stucco

Install the vinyl siding the siding begins flush with the sill plate or the bottom of the stucco wall.

Applying vinyl siding over stucco.

Pre drill holes in the furring strips about 8 inches apart. A few things change when installing vinyl siding over stucco however. For homes with stucco exteriors a framework of wood furring strips must first be installed to create a level surface which suspends the outer layer of siding over the inner layer so that water cannot settle between the two and cause rot and erosion. This would cause major problems.

Use 2 by 4 inch strips made from treated wood because stucco being a masonry product can absorb moisture and transfer it to the furring strips. The area where the siding is being applied is wrapped with a double layer of insulating wrap before the siding is installed on the house. Install furring strips vinyl and other types of siding attach every 16 inches so you ll need vertical furring strips 16 inches apart. New siding can be installed over existing exterior coverings in some cases.

Each new piece of siding overlaps the previous piece and is leveled to ensure a true horizontal line. Vinyl siding is held in. Stucco is the type of decorative plaster that is applied usually on the exterior of a house in order to enhance its curb appeal. Then furred chicken wire is applied over the top of that sticking out from the home a bit so that the stucco can be applied.

Lap or vinyl siding begins flush with the sill plate or at the bottom of the stucco wall. Installing siding over existing stucco does not give us a chance to identify underlying rot issues so if you have any concerns a full removal could be your best bet. The siding ends are placed directly next to the edge of the wall door frames or window frames. The scratch or base layer is applied.

To apply vinyl siding to a home you must first remove the exterior coatings and prepare the surface. The trim should hide the siding panels edges and ends but you want a little space to account for material expansion and contraction. Stucco has to be applied to an even surface usually over wood covered with wire mesh and roofing felt. Vinyl siding is a decorative and protective material made up of plastic which takes the form of a wood clapboard and serves the purpose of weatherproofing along with enhancing the exterior look of a house.

You will need to remove the vinyl siding before applying stucco. To start you can t just attach vinyl siding directly to the old stucco.